Installation, Adjustments And Maintenance; Unpacking; Adjusting; Electrical Requirement - Haier BD-203GAA Service Manual

Hide thumbs Also See for BD-203GAA:

Table of Contents

SERVICE MANUAL

Model: BD-203GAA

Chapter 3 Installation, adjustments and maintenance

1. Remove all packaging material; this includes the foam base and all adhesive tape holding the

freezer accessories inside and outside.

2. Inspect and remove any remains of packing, tape or printed materials before powering on the

freezer.

1. The freezer is designed for freestanding installation only. It should not be recessed or built-in.

2. Place the freezer on a floor strong enough to support it fully loaded.

3. When moving freezer, never tilt it more than a 45-degree angle. This could damage the compressor

and the sealed system.

4. If freezer is tilted let it stand in an upright position for at least 24 hours prior to plugging. This is to

allow the refrigerant to settle.

5.Proper Air Circulation

To assure the freezer works at the maximum efficiency it was designed for, you should install it in a

location where there is proper air circulation, Plumbing and electrical connections.

The following are recommended clearances around the freezer:

Sides..............2"(50mm)

Top. ...............2"(50mm)

Back..............2"(50mm)

Do not over fill freezer for proper internal air circulation.

Make sure there is a suitable power Outlet with proper grounding to power the freezer.

Avoid the use of cutting off the third grounding, this is a dangerous practice since it provides no

effective grounding for the freezer and may result in shock hazard.

Issue 2009-12-17

Ref0912S017V0

Rev.

Table of Contents

Show Quick Links

Table of Contents