SERVICE MANUAL
Sides..............2"(50mm)
Top. ...............2"(50mm)
Back..............2"(50mm)
Do not over fill freezer for proper internal air circulation.
3-3.Electrical Requirement
Make sure there is a suitable power Outlet with proper grounding to power the freezer.
Avoid the use of cutting off the third grounding, this is a dangerous pr
grounding for the freezer and may result in shock hazard.
3-4.Defrost
Defrosting and Draining
●
1. Defrost whenever the frost becomes 5MM thick. Never use a sharp or metallic instrument to remove
the frost as it may damage the cooling coils.(A punctured coil will void the warranty)
2. Unplug the unit. For draining, place a tray beneath the outer drain plug. Pull out the drain dial and
rotate it so that the arrow points down
●
3. Remove the drain plug from the inside of the freezer. Defrosting usually takes a few hours. To defrost
faster keep the freezer door open. When done, push the drain dial in and turn the arrow to the up
position. Re-plug the drain plug inside the freezer compartment. Note: monitor the container under the
drain to avoid overflow.
·Rest the temperature control to the desired setting.
3-5. Cleaning
Outside. Protect the paint finish. The finish on the outside of the freezer is a high quality baked-on
paint finish. With proper care, it will stay new-looking and rust-free for years. Apply a coat of appliance
polish wax when the freezer is new and then at least twice a year. Appliance polish wax also works well
to remove tape residue from freezer surfaces.
Keep the finish clean. Wipe with a clean cloth lightly dampened with appliance polish wax or mild
liquid dishwashing detergent. Dry and polish with a clean, soft cloth. Do not wipe the freezer with a soiled
the Freezer
ward. This will let the water flow out into the tray.
●
actice since it provides no effective
●
7
●
7