Makita JR100D Instruction Manual page 6

For the switch trigger, depress the lock-off button
•
and then pull the switch trigger to start to the tool.
The lock-off button can be pressed from either right
or left.
The tool speed is increased by increasing pressure on
the switch lever/trigger. Release the switch lever/trigger
to stop.
NOTICE:
Do not pull the switch lever/trigger hard without pulling
the lock-off lever/button. This can cause switch
breakage.
Lighting up the front lamp
Fig.3
CAUTION:
Do not look in the light or see the source of light
•
directly.
Pull the switch lever/trigger to light up the lamp. The
lamp keeps on lighting while the switch lever/trigger is
being pulled.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing the saw blade
CAUTION:
Always clean out all chips or foreign matter
•
adhering to the blade, blade clamp and/or slider.
Failure to do so may cause insufficient tightening
of the blade, resulting in a serious injury.
For Model JR100D
Fig.4
Insert the recipro saw blade into the blade clamp as far
as it will go. The blade clamp sleeve rotates and the saw
blade is fixed. Make sure that the saw blade cannot be
extracted even though you try to pull it out.
CAUTION:
If you do not insert the saw blade deep enough, the
•
saw blade may be ejected unexpectedly during
operation. This can be extremely dangerous.
NOTE:
You can not use the jig saw blade with JR100D
•
Fig.5
To remove the saw blade, rotate the blade clamp sleeve
in the direction of the arrow fully. The saw blade is
removed and the blade clamp sleeve is fixed at the
released position.
NOTE:
If you remove the saw blade without rotating the
•
blade clamp sleeve fully, the sleeve may not be
fixed. In this case, rotate the blade clamp sleeve
fully, then make the sleeve fixed at the released
position.
For Model JR102D
Fig.6
1
3
1. Recipro saw blade
2. Hex wrench
3. Hole for recipro saw blade
4. Blade clamp
013062
To install the saw blade, loosen the bolt by hex wrench.
When installing a recipro saw blade, press the bolt with
the hex wrench to open the slot during inserting the
blade.
Fig.7
Fig.8
You can use both jig saw blades (B type) and recipro
saw blades according to your work. Insert the saw blade
straight into the blade clamp and tighten it by hex
wrench. Pull the saw blade lightly to make sure that the
saw blade does not fall off during operation.
To remove the saw blade, follow the installation
procedure in reverse.
Hex wrench storage
Fig.9
When not in use, store the hex wrench. It is fixed by two
projections as shown in the figure to keep it from being
lost.
6
2
4