For Vigor2910G - Draytek Vigor 2910 User Manual

1 . 2 . 2 F o r V i g
1 . 2 . 2 F o r V i g
L E D E
L E D E
LED
ACT (Activity)
DMZ
QoS
Attack
WLAN
USB *
WAN(W1-W2)
LAN (P1, P2, P3,
P4)
C o n n e
C o n n e
Interface
USB*
PWR
ON/OFF
LAN P4 – P1
W2/W1
Factory Reset
Note: For the USB port can be used to connect 3G USB modem or USB printer, therefore
the original name (printer) is changed into USB in the future.
Vigor2910 Series User's Guide
o r 2 9 1 0 G
o r 2 9 1 0 G
x p l a n a t i o n
x p l a n a t i o n
Status
Blinking
Off
On
On
Off
On
Blinking
On
Blinking
Off
On
Orange
Green
Blinking
Orange
Green
Blinking
c t o r E x p l a n a t i o n
c t o r E x p l a n a t i o n
Description
Connecter for a USB printer or 3G USB modem.
Connecter for a power adapter with 12-15VDC.
Power Switch.
Connecters for local networked devices.
Connecter for accessing Internet with the ADSL,ADSL2/2+ line
Restore the default settings.
Usage: Turn on the router (ACT LED is blinking). Press the hole and keep
for more than 5 seconds. When you see the ACT LED begins to blink rapidly
than usual, release the button. Then the router will restart with the factory
default configuration.
Explanation
The router is powered on and running properly.
The router is powered off.
DMZ Host is specified in certain site.
The QoS function is active.
The QoS function is inactive.
DoS Defense function is active.
An attack is detected.
Wireless access point is ready.
Wireless traffic goes through.
Wireless access point is turned off.
The USB interface printer or 3G USB modem is ready.
A normal 10Mbps WAN link is ready.
A normal 100Mbps WAN link is ready.
Ethernet packets are transmitting.
A normal 10Mbps connection is through its corresponding
port.
A normal 100Mbps connection is through its
corresponding port.
Ethernet packets are transmitting.
3