Draytek Vigor 2910 User Manual page 146

Volume Gain
MISC
Authentication PIN Code
DTMP
140
User Defined and fill out the corresponding values for dial
tone, ringing tone, busy tone, congestion tone by yourself for
VoIP phone.
Also, you can specify each field for your necessity. It is
recommended for you to use the default settings for VoIP
communication.
Mic Gain (1-10)/Speaker Gain (1-10) - Adjust the volume of
microphone and speaker by entering number from 1- 10. The
larger of the number, the louder the volume is.
Dial Tone Power Level - This setting is used to adjust the
loudness of the dial tone. The smaller the number is, the
louder the dial tone is. It is recommended for you to use the
default setting.
Check for ISDN to VoIP Calls – Set a pin code for the router
to authenticate which one is allowed to dial ISDN to VoIP call.
The figure that you can type in this field is limited from three
to eight with digits from zero to nine.
Check for VoIP to ISDN Calls - Set a pin code for the router
to authenticate which one is allowed to dial VoIP to ISDN call.
The figure that you can type in this field is limited from three
to eight with digits from zero to nine.
DTMF mode – There are four selections provided here:
InBand:Choose this one then the Vigor will send the DTMF
tone as audio directly when you press the keypad on the phone
OutBand: Choose this one then the Vigor will capture the
keypad number you pressed and transform it to digital form
then send to the other side; the receiver will generate the tone
according to the digital form it receive. This function is very
useful when the network traffic congestion occurs and it still
can remain the accuracy of DTMF tone.
SIP INFO: Choose this one then the Vigor will capture the
DTMF tone and transfer it into SIP form. Then it will be sent
to the remote end with SIP message.
Vigor2910 Series User's Guide