Draytek Vigor 2910 User Manual page 40

After finishing all the settings here, please click OK to activate them.
D e t a i l s
D e t a i l
For static IP mode, you usually receive a fixed public IP address or a public subnet, namely
multiple public IP addresses from your DSL or Cable ISP service providers. In most cases, a
Cable service provider will offer a fixed public IP, while a DSL service provider will offer a
public subnet. If you have a public subnet, you could assign an IP address or many IP
address to the WAN interface.
To use Static or Dynamic IP as the accessing protocol of the internet, please choose
Internet Access from WAN menu. Then, select Static or Dynamic IP mode for WAN2.
The following web page will be shown.
Static or Dynamic IP
(DHCP Client)
ISDN Dial Backup
Setup
34
Specify a MAC Address – Type the MAC address for the router
manually.
P a g e f o r S t a t i c
s P a g e f o r S t a t i c
Click Enable for activating this function. If you click Disable,
this function will be closed and all the settings that you adjusted
in this page will be invalid.
This setting is available for the routers supporting ISDN function
only. Before utilizing the ISDN dial backup feature, you must
create a dial backup profile first. Please click Internet Access
Setup > Dialing to a Single ISP to enter the backup profile.
Due to the absence of the ISDN interface in some models, the
ISDN dial backup feature and its associated setup options are not
available to them. Please refer to the previous part for further
information.
o r D y n a m i c I P
o r D y n a m i c I P
Vigor2910 Series User's Guide