Team Blacksheep TBS TANGO 2 Radio Manual page 51

FAQ
My TANGO does not bind to the receiver - both are blinking slowly green
●
○ Update your build-in CROSSFIRE to 3.73 (beta) or later and retry
After binding, the receiver shows a double pattern and I get no signals in BF/ iNav/ ...
●
○ This is an authentication error on the CROSSFIRE. To solve it:
■
■
■
■
■
○ After a few seconds, the green led on the receiver should switch to a constant green light
● I get movements BF/ iNav/ ... on the 4 sticks but not from any switch
○ You need to assign the switches in the "Mixer" page of your model to a channel you'd like it
to be. For detailed information on the mixer page, have a look at
video series
The switches on channel 9 and following do not show any movement in BF
●
Open the Agent Lite/ CROSSFIRE receiver/ General/ Mode: 12Ch
○
● I can no longer see the Frequency setting and the output power is limited
Your CROSSFIRE is in a region-lock mode. This mode makes sure that non-allowed settings
○
are not available. If you have set it the by accident,
● In Agent X/ M/ Lite the CROSSFIRE and WiFi modules do not show up
Navigate in the Model settings, page 1 and disable the external module
○
Manual written and designed by ivc.no in cooperation with TBS and Kamikatze-fpv.de.
Shut down your drone and the TANGO
Power up the TANGO
Set it in Bind-mode
Power up the receiver
Push the bind button on the receiver
here is how you can unlock it
51
Painless360's OpenTX