Team Blacksheep TBS TANGO 2 Radio Manual page 45

Update the SD card content
You can download the content manually from the
to select the correct version depending on your FreedomTX version.
Update from FreedomTX 1.XX to 1.2X or later
Due to the massive changes coming with FreedomTX 1.2X, the update process from a lower version differs
from the normal update routine:
● Update FreedomTX
● Now the update process stops at Verification and the T2 Display shows Pls update CROSSFIRE
● When you leave the FreedomTX overview in Agent X you'll find the Micro TX in Bootloader mode -
update the CROSSFIRE to 4.00 or later
● This will take only a few seconds and the radio will then boot up normal
Now update the CROSSFIRE Micro TX again - in the first time only the transmitter firmware sent to
●
the radio - now you also the receiver firmware are transferred
Update your SD card content
●
Once you are on 1.2X or later, this is no longer necessary.
Firmware dependencies
Certain firmware versions require other devices to have a minimum version to work properly:
● FreedomTX 1.1X -> CROSSFIRE 3.XX
FreedomTX 1.2X -> CROSSFIRE 4.00 (or later)
●
● FreedomTX 1.25 -> CROSSFIRE 4.10 (or later)
FreedomTX 1.29 -> CROSSFIRE 4.11 (or later)
●
TANGO 2 shop page when you scroll down - make sure
1. Power up your TANGO 2 and connect it by
USB-C
2. In the prompt, select USB Storage (SD)
3. Wait for your pc to mount the drive
4. Copy the complete content into the SD card of
the TANGO 2 and override the existing files
45