Draytek Vigor 5510Gi User Manual page 37

D e t a i l s
D e t a i l
To use PPPoE as the accessing protocol of the internet, please choose Internet Access from
WAN menu. Then, select PPPoE mode for WAN2. The following web page will be shown.
PPPoE Client Mode
ISP Access Setup
ISDN Dial Backup
Setup
PPP/MP Setup
IP Address
Assignment Method
VigorPro5510 Series User's Guide
P a g e f o r P P P o E
s P a g e f o r P P P o E
Click Enable for activating this function. If you click Disable, this
function will be closed and all the settings that you adjusted in this
page will be invalid.
Enter your allocated username, password and authentication
parameters according to the information provided by your ISP. If
you want to connect to Internet all the time, you can check Always
On.
Username – Type in the username provided by ISP in this field.
Password – Type in the password provided by ISP in this field.
Index (1-15) in Schedule Setup - You can type in four sets of time
schedule for your request. All the schedules can be set previously
in Application – Schedule web page and you can use the number
that you have set in that web page.
This setting is available for the routers supporting ISDN function
only. Before utilizing the ISDN dial backup feature, you must
create a dial backup profile first. Please click Internet Access
Setup > Dialing to a Single ISP to enter the backup profile.
This setting is available for i model only.
PPP Authentication – Select PAP only or PAP or CHAP for
PPP.
Idle Timeout – Set the timeout for breaking down the Internet
after passing through the time without any action. This setting is
active only when the Active on demand option for Active Mode is
selected in WAN>> General Setup page.
Usually ISP dynamically assigns IP address to you each time you
connect to it and request. In some case, your ISP provides service
to always assign you the same IP address whenever you request.
29