For Vigorpro 5510Gi - Draytek Vigor 5510Gi User Manual

1 . 2 . 2 F o r V i g
1 . 2 . 2 F o r V i g
LED
ACT (Activity)
IDP (Intrusion Detection and
Prevention)
Virus
DMZ
USB
WLAN
Monitor
CSM
ISDN
LED on Connector
WAN
LAN/Monitor
LAN
Interface
RST
(Factory Reset)
4
o r P r o 5 5 1 0 G i
o r P r o 5 5 1 0 G i
10
(left LED)
100
(right LED)
100
(left LED)
1000
(right LED)
Description
Restore the default settings.
Usage: Turn on the router (ACT LED is blinking). Press the hole and keep for
more than 5 seconds. When you see the ACT LED begins to blink rapidly than
usual, release the button. Then the router will restart with the factory default
Status Explanation
Blinking The router is powered on and running normally.
Off The router is powered off.
On The anti-intrusion function is enabled.
(Yellow)
On The anti-virus function is enabled.
(Yellow)
On DMZ Host is specified in certain site.
On A USB device is connected and active.
Blinking The data is transmitting.
On Wireless access point is ready.
Blinking Ethernet packets are transmitting over wireless LAN.
Off The WLAN function is inactive.
On LAN traffic monitor is active.
On The profile(s) for IM/P2P, Web Content Filter,
and/or URL Content Filter application has been
activated. (It is enabled from Firewall >> General
Setup).
Off No IM/P2P, Web Content Filter, and/or URL
Content Filter application has been activated.
On The ISDN service function is active.
Blinking A successful connection on the ISDN BRI B1/B2
channel.
On The port is connected with 10Mbps.
Off The port is disconnected.
Blinking The data is transmitting.
On The port is connected with 100Mbps.
Off The port is disconnected.
Blinking The data is transmitting.
On The port is connected with 100Mbps.
Off The port is disconnected.
Blinking The data is transmitting.
On The port is connected with 1000Mbps.
Off The port is disconnected.
Blinking The data is transmitting.
VigorPro5510 Series User's Guide