FIP FLS F3.00.W Manual page 9

Receiver installation
Wall mounting W1-W2
1. Clean the surface where the PCB must be
glued
3. Remove the protective film from the PCB
support already mounted
4. Install the PCB according to the picture.
Installation on the upper part of the box is
reccommended.
DIN bar adapter
1. Remove the external fins following the dotted line indication on the receiver
PCB see figure 1
2. assemble the receiver PCB following the sequence in the figure 2
REMOVABLE PART REMOVABLE PART
Fig.1
CUTTING LINE CUTTING LINE
Fig.2
9