Advertisement
Operating Instructions
The LED display screen on the control panel of the product illuminates to display what
function you have selected when the fan is operating.
a.
Turning on/off the fan: Gently press "Standby" button
control panel or the wireless remote control.
b.
Adjusting and Selecting Speed: 3 contant speeds can be selected by pressing the
button
either on the control panel or on the remote. Each time you press this
button the speed will cycle from I to II to III and back to 'I' again. Where "I" = Low
Speed, "II" = Medium Speed and "III" = High Speed.
c.
Oscillating function: The product oscillates in an arc from left to right and back
again continuously thus circulating the air flow over a wider area. To start the tower
fan oscillating simply press the oscillating button
than 2 seconds or the
the control panel. Press this button a second time to stop the oscillating.
d.
Variable Blower Function Selection: The product can be set to automatically vary
the speed output to simulate different breezy conditions. It will normally run in
constant blowing mode at whichever speed you selected (see "b." above). To select
a variable blower speed function you can simply press the
or press and hold the dual control button
seconds. There are two selections available:
1. The first mode activated will be the 'natural breeze' selection and the
will light up on the control panel. In this mode the fan speed will continuously
and randomly vary between speed levels (including off) to simulate variable
wind conditions.
2. Pressing the
control button
time' selection and the
the fan speed varies automatically between speed levels (including off) at a less
noticeable rate than the 'natural breeze' selection.
- Pressing the
to constant normal blowing mode.
e.
Runback Timer function: The product can be set to switch off automatically after
running for one of the four user selectable runback periods i.e. 1 hr, 2 hr, 4 hr or 8 hr.
To activate the runback function just simply press the timer
-
Press once and the timer is set to 1hr runback
-
Press twice and the timer is set to 2hr runback
-
Press 3 times and the timer is set to 4hrs runback
-
Press 4 times and the timer is set to 8 hrs runback
-
Press a 5th time and the timer function is switched off.
button on the remote and the
on the remote a second time or pressing and holding the dual
on the control panel again for atleast 2 seconds activates 'night
symbol will light up on the control panel. In this mode
button a third time for more than 2 seconds will change it back
on the soft touch button
on the control panel for less
symbol will light up on
button on the remote
on the control panel for at least 2
symbol
button
Advertisement
