Advertisement
How to assemble the base
Carefully remove the split base and the tower fan from its
packaging.
Pass the power cord between the centre of the two halves split base
and fit the two halves' together by lining the overlap bosses on the
bottom (with cable exit) with their sockets on the other half dropping
into place and pressing together.
Bring the assembled base up to the bottom of the tower and line up
the small pillar on the top of the raised centre of the base with the
matching hole in the base socket location of the tower fan, pull the
cable through fully so it doesn't interfere with them fitting together.
Take the 4 large screws provided and pass them through the holes in
the circular bosses (located around the central hub on the underside
of the base) into the bottom of the tower, screw fix them firmly in
place.
Carefully fit the cable through the slot to the back side of the hub
and then through the guide location channel at the outside of the
circular base to exit level with the base through the channel at the
Fig. 1
back. The XPP Cooling fan is now ready to stand and operate.
THIS IS NOT A FAULT
If the fan speed varies randomly including stopping and starting automatically you have
selected either NATURAL
or NIGHTIME
Variable Blower Mode which simulate
different breezy conditions. To de-select this mode you must press the
button to
change back to constant blowing mode, please refer to section 'd' following on how
to change modes. To run in constant speed mode only use the
button to select the
speed you require, please refer to section 'b' following.
Advertisement
