Pentair HYPRO PROSTOP-E Installation And Operation Manual page 4

INSTALLATION & OPERATION
Nozzle Body Clamp Torque: 17 inlbs.
Connector Information:
M12 style

IN: A-Code Keying

OUT: D-Code Keying

Termination Cap 2300-0067 required for protection of
any unused connector port
DIGITAL/LINBUS OPERATION
The ProStop E Single is compatible with Pentair Cannode

with firmware revision 1.05 and higher (PN CN32-0001) to
allow this product to integrate into an ISOBUS system.
Each Pentair Cannode supports up to 32 ProStop E Single

nozzle bodies while maintaining individual nozzle control.
Multiple Pentair Cannodes can be used in the same system
to support any number of ProStop E nozzle bodies.
For information on individual Cannode operation,

reference L-1586 or contact Hypro Service Center.
ANALOG OPERATION
When a 12VDC signal is sent to the Analog pin, the valve

will open. When the signal is removed, the valve will close,
similar to controlling a conventional section valve.
4
L-3111 (04-15-21)