Controlling Combo Devices - Philips Elite SRP4219G/07 User Manual

Programming your remote
8. Repeat this process for each device you wish
to control.

Controlling combo devices

Some combo devices (e.g., TV/VCR, TV/DVD, DVD/
VCR, etc.) will require you to set up two different
device buttons to control both parts of the combo
device. For example, if you have a TV/DVD combo,
you may need to set up one code under the TV
button to control the TV and a separate code
under the DVD button to control the DVD.
SRP4229B_07 ENG Manual v2.indd 9 SRP4229B_07 ENG Manual v2.indd 9
Did the device turn off?
• If YES, you have found a code for
the device. Press and release the
same device button you pressed
in Step 3. This will store the code
in the remote. Go to Step 7.
If NO, continue to press and
•
release the VOL
the device turns off to test the
other 9 codes from Step 4. Be sure
to wait approximately 3 seconds
after each VOL
allow the device time to respond
to the code. When the device
turns off, you have found a code
for your device. Press and release
the same device button pressed in
Step 3. This will store the code in
the remote. Go to Step 7.
NOTE:
• The
go backwards through each batch
of 10 codes.
• The red indicator light will flash 2
times after testing the first or last
code in each batch of 10.
7. Use the remote to turn the device
back on. Test the buttons on the
remote to see if the device responds
as you would expect. If the buttons
do not operate the device, return
to Step 2 and repeat this process to
search for a better code to operate
the device.
button press to
VOL
button can be used to
9
button until
9/2/21 5:03 PM 9/2/21 5:03 PM