Electrolux EDC78550W User Manual page 5

Important!
• The hot air emitted by the tumble dryer
can reach temperatures of up to 60°C.
The appliance must therefore not be in-
stalled on floors which are not resistant to
high temperatures.
• When operating the tumble dryer, the
room temperature must not be lower
than +5°C and higher than +35°C, as it
may affect the performance of the appli-
ance.
• Should the appliance be moved, it must
be transported vertically.
• The appliance must not be installed be-
hind the lockable door, a sliding door a
door with a hinge on the opposite side to
that of the appliance in such a way that a
full opening of the dryer is restricted.
Removing transport safety packaging
Caution!
Before use all parts of the transport pack-
aging must be removed.
1. Open loading door
2. Pull off adhesive strips from inside ma-
chine on top of drum.
3. Remove foil hose and polystyrene pad-
ding from the machine.
Electrical connection
Details on mains voltage, type of current
and the fuses required should be taken
from the type plate. The type plate is fitted
near the loading aperture (see "Product de-
scription" chapter).
Connect the machine to an earthed
socket, in accordance with current wir-
ing regulations.
Warning! The manufacturer
declines any responsibility for
damage or injury through failure to
comply with the above safety
precautions.
Should the appliance power supply
cable need to be replaced, this
must be carried out by our Service
Center.
Warning! The plug must be
accessible after installing the
machine.
Door reversal
To make it easier to load or unload the
laundry, the door can be reversed.
Warning! The door must only be
reversed by an authorised service
engineer.
Please contact your local Service Force
Centre. The engineer will carry out the door
reversal at your cost.
Special accessories
• Stacking kit
These intermediate installation kits can
be used to arrange the dryer and a wash-
ing machine (60 cm wide, front loaded)
as a space-saving washer/dryer stack.
The washing machine is at the bottom
and the dryer is at the top.
Read carefully the instructions supplied
with the kit.
Available from your Service Force Cen-
tre or your specialist dealer
• Draining kit
Installation kit for direct draining of the
condensed water into a basin, siphon,
gully, etc. The water reservoir then no
longer has to be drained, it must however
remain in its intended position in the ma-
chine.
Fixed hose has to be on the suitable
height from minimum of 50 cm to maxi-
mum of 1 m from floor level and cannot
be looped. If possible shorten the drain-
ing hose.
Read carefully the instructions supplied
with the kit.
Available from your Service Force Cen-
tre or your specialist dealer
• Pedestal with the drawer
electrolux 5
1