Porter-Cable PCEG011 Instruction Manual page 8

(3) into the desired working position. The
guard body should be positioned between
the spindle and the operator to provide
maximum operator protection.
4. Figure C - Close the guard latch to secure
the guard on the gear case. You should
not be able to rotate the guard by hand
when the latch is closed. Do not operate
the grinder with a loose guard or the
clamp lever in open position.
5. REMOVING - To remove the guard,
open the guard latch, rotate the guard
so that the lugs on the guard are
aligned with the slots on the gear case
cover, and pull up on the guard.
B
8
C
FIGURE D
NOTE:
The guard is pre-adjusted to
the diameter of the gear case hub at the
factory. If, after a period of time, the guard
becomes loose, tighten the adjusting
screw (10) with latch in the closed position
and guard installed on the tool.
CAUTION:
Do not tighten the
adjusting screw with the latch in the open
position. Undetectable damage to the guard
or the mounting hub may result. If the guard
cannot be tightened by the guard latch, do
not use the tool and take the tool and guard
to a service center to repair or replace
the guard.
NOTE
: Edge grinding and cutting
can be performed with Type 27 wheels
designed and specified for this purpose;
1/4" (6.35 mm) thick wheels are designed
3
8
for surface grinding while thinner Type
27 wheels need to be examined for the
manufacturer's label to see if they can be
used for surface grinding or only edge
grinding/cutting. A Type 1/41 guard must
be used for any wheel where surface
grinding is forbidden. Cutting can also be
performed by using a Type 1/41 wheel
and a Type 1/41 guard.
D
10
OPERATING INSTRUCTIONS
WARNING:
Always use proper eye
protection that conforms to ANSI Z87.1(CAN/
CSA Z94.3) while operating this power tool.
Use clamps or another
WARNING:
practical way to secure and support
the work piece to a stable platform.
Holding the work by hand or against your
body leaves it unstable and may lead to
loss of control.
:
NOTE Before cutting any type of
material, be sure it is firmly anchored or
clamped to prevent slipping.
SLIDE SWITCH
CAUTION:
Hold the auxiliary handle
(5) and body of the tool (4) firmly to maintain
control of the tool at start up and during use
and until the wheel or accessory stops
rotating. Make sure the wheel has come to a
complete stop be fore laying the tool down.
CAUTION:
Allow the tool to reach
full speed before touching tool to the work
surface. Lift the tool from the work
surface before turning the tool off.
• To start the grinder, push the slider
switch (1) forward using the edge of
the slider toward the rear of the unit.
Release the slider switch to turn the
grinder off.
• For continuous operation, slide and
depress the switch forward until it
locates the lock ON position.
• To turn the tool off, press the rear
of the slider switch. A spring action
returns the switch to the OFF position.