Battery Replacement - Fluke 28 II Ex Calibration Information Manual

28 II Ex
Calibration Information

Battery Replacement

Replace the batteries with three AAA batteries (NEDA 24A IEC LR03).
To prevent possible electrical shock, fire, or personal injury:
•
•
Replace the batteries as follows, refer to Figure 2:
1. Turn the rotary switch to OFF and remove the test leads from the terminals.
2. Remove the six Torx-head screws from the case bottom and remove the battery door
When you lift the battery door, make sure the rubber gasket stays attached
to the battery compartment barrier.
3. Remove the three batteries and replace all three with AAA Alkaline batteries
4. Make sure the battery compartment gasket (item ) is properly installed around the
10
Good 0.44 A fuse: 0.995 kΩ to
Replace fuse: OL
Touch top half
of input contacts
Good 11 A fuse: 0.0 Ω to
Replace fuse: OL
Figure 1. Current Fuse Test
Replace the batteries when the low battery indicator ()
shows to prevent incorrect measurements. If the display
shows "batt" the Product will not function until the
batteries are replaced.
Use only three AAA 1.5 volt batteries, correctly installed to
power the Product. See the table on the subsequent page
for a list of approved batteries. All cells are to be replaced at
the same time with same part number cells in fresh air
locations only.
(item ).
(item ).
1.005 kΩ
0.5 Ω
XWWarning
Note
gaq105.eps