Password
Beep operation
VAIE 5500
Setting a password
Panel for enabling, disabling and customising the password for logging into the
system service levels. The default passwords set are those shown here on the
left. To change these settings and enter a new code, press the key associated
with the menu in which the change is to be made and, on the next sub-panel,
enter the new password.
To correct a typing error, use the Canc key.
To enable / disable a password, use the Enable password or Disable
password keys (as the case may be).
Press Enter to confi rm and return to the Password menu panel.
Press Save to save the change made.
To return to the CONFIGURATION menu press Escape.
Set the control 'beep'
From this screen, the acoustic fault (conventionally known as a 'beep') can be
set.
- Beep enable / disable:
Move the cursor to the 'On' position (beep enabled) or to the 'Off' position
(beep not enabled), as needed (see the "N.B." note below).
- Beep level:
Adjustment of the beep volume, which can be set at one of three different
levels (1 / 2 / 3 / Off). Press the Change key until the desired volume is
reached.
To return to the CONFIGURATION menu, press Escape.
! N.B.
In order to comply with the regulations, before using the equipment for
normal operation it is necessary to enable the acoustic signalling by setting
'Beep enable' to the 'On' position.
35
EN