STEP 6:
Check all the connection first and connect the load to the system, Load+ is linked to the "load+" at
the controller, Load- links to the "FC- and load-" in the stack shown in 6A
STEP 7:
Direct the outlet tubing of the purge valve away from the fuel cell. Do not let the purged hydrogen go
back towards the fuel cell stack, this will damage the fuel cell.
Purged Hydrogen away from the stack
Manual_FCS-C100_V2.2_EN
6A
7A
Note: The tube is required to be less than 20cm
between stack output and purging valve. The tube
connected to the purging valve output is required
to be less than 30cm. The inner diameter of the
required to be more than 2mm.
18