Horizon Fitness H-100 User Manual page 14

7. Controller Connector
Connect the stack to the T-sensor/blower/purging valve/
input valve on the controller.
8. Controller
Controls the stack temperature, blowers, hydrogen input,
purging and short circuiting of the stack.
9. H2 Input/Output connectors
H2 OUT: connect the tube shown in 11 below.
H2 IN: connect the tube shown in 11 below.
10. Fuel Cell +/Fuel Cell-&Load- Connectors
FC+ of the controller is connected to the fuel cell positive
pole.
FC- of the controller is connected to the fuel cell negative
pole.
11. Tube for H2 Input and Output
The tube with 6mm outer diameter and 3mm inner
diameter is connected to the H2 IN as in 9 above and to
the input valve of the hydrogen source. H2 output tube
with 4mm outer diameter and 2mm inner diameter is
connected to the purging valve on one end and the H2
OUT the other.
12. Grounding cable
Make stack grounded.
Note: After the fuel cell stack is finished using, disconnect
the grounding cable.
Manual_FCS-C100_V2.2_EN
11