Adjust The Air Pressure - YILMAZ DK 502 User Manual

8.2 Changing the cutting tool
8.2.1 Open the protection cover.
8.2.2 Loosen the stay bolt located on tension sheet bar of the teflon paper with Allen and pull the teflon group to forward and
take it completely out. (PICTURE 9)
8.2.3 Remove the hexagon bolt on teflon connection stay bolt and change the teflon paper. By conducting the reverse
course of action that were done while removing and fix the new teflon paper to the connection sheet bar.
8.2.4 Fasten the teflon Group that is formed after conducting it to the resistance plate and stretching it upwards and by
fixing them with the aid of M6 stay bolts. (PICTURE 10)
PICTURE-9
8.3 Adjust the air pressure (pneumatic systems)
8.3.1 Pull up pressure adjustment valve. Set adjustment valve to the
desired value on manometer by turning it clockwise or counter
clockwise. Then lock the valve by pressing it down.
8.3.2 Set the air pressure between 6 and 8 BAR. If air pressure drops
below the stated values, accessories operating with pneumatic power
do not work.
8.3.3 Conditioner unit accumulates the water in the air in the collection
container so that it won't damage pneumatic components. At the end
of the working day, empty the accumulated water by opening water
discharge valve under the collection container.
8.3.4 In order to put oil to the oil tank, remove the reservoir by turning.
Oils recommended by the manufacturer are;
ENERGOL HLP 10 / MOBIL DTE LIGHT / PETROL OFİSİ SPINDURA
10.
Allen Screw
Teflon Paper
TELLUS C10 / BP
Teflon paper
stretching plate
Teflon paper
connection plate
PICTURE-10
34