Installation Of The Machine; Preparation; Connecting To Power Source; Machine's Safety Information - YILMAZ DK 502 User Manual

5. INSTALLATION OF THE MACHINE

5.1 Preparation

5.1.1 The machine size and weight measurements, given the technical specification sheet.The ground, where the machine
will be placed, should be even, solid enough to bear the weight of the machine.
5.1.2 The machine should be located approx. 100 cm away from the rear wall. On the backside of the machine you will find
connection tube for the collection of burr and swarf, hydro-pneumatic system, cable channels, power supply connection
plug.
5.1.3 You can provide the balance of the machine with adjustable counterforts (FIGURE 3 NO 129-1) in the bottom part.

5.2 Connecting to Power Source

5.2.1 Electrical connection must be made by a licensed electrician
5.2.2 The power outlet socket on the machine should be available.
5.2.3 Plug the machine to a grounded socket.
5.2.4 Mains voltage of the machine is optional as 230 V 50 Hz or 400 V 50 Hz.
5.2.5 Check the supply voltage. The source voltage must be in accordance with the data
on the machine's label.

6. MACHINE'S SAFETY INFORMATION

6.1 Lifting, installation, electric maintenance of the machine should be carried out by qualified personnel only.
6.2 Routine maintenance and scheduled maintenance should be carried out by qualified personnel after unplugging the
machine first.
6.3 Ensure that the machine has been cleaned, tested and maintained before starting to operate it.
6.4 Check the safety devices, power cable and moving parts regularly. Don't operate the machine before having replaced
defective safety devices or faulty parts.
6.5 Never replace the cutting tools before unplugging first.
6.6 Keep foreign materials away from the working area of the machine, keep away from the machine's moving parts.
6.7 Do not work on the machine by removing the protective parts
The safety data have been defined above. In order to prevent physical damage or damage to the
equipment, please read the safety information carefully and keep the manual always in an easy
accessible place.

7.0 OPERATION INFORMATION

7.1 Preparation
7.1.1 Degrease and dry the machine table. Especially ensure that the holding grips and handles are clean and dry
7.1.2 Clean all surfaces of the machine from chip and foreign particles. Use eye glasses for protection.
7.1.3 Check for appropriate temperature and time for the PVC profile to be welded
26