Operation - YILMAZ DK 502 User Manual

7.2 OPERATİON (FOR DK 502 MODELS)
Double Head Weldıng Operatıon

Open the power and air supply units.

Ensure that the head selection button on the fixed head (PICTURE 6 NO.125) is in the position "1-2".

Press the two Start buttons on the fixed head (PICTURE 6 NO.117) at the same time until their green lights are on.

Check whether the brake button located on the movable head (PICTURE 6 NO.134) is "OFF". If the brake button is not in
"OFF" position, the machine will not work.

Put the brake button to "ON" and adjust the movable head to the desired position. Place the profile between the two heads,
and put the brake button to "OFF" (closed). (PICTURE 6 No 134)

Place the other profile onto the movable head. Clamp the profiles by pressing the Start button twice

Go to the fixed head and position the other profile. Clamp the profiles by pressing the Start button separately.
OPERATİON (FOR DK 502 MODELS)
Double Head Weldıng Operatıon
Open the power and air supply units.
Indicates the PLC and Screen version numbers
Password entry page. (Password 1234)
PLC versiyonu
Ekran versiyonu
28