2.3.2 Mounting The Device To A Panel - Siemens SIMATIC NET RUGGEDCOM RX1512 Installation Manual

Installing the Device
2.3.2 Mounting the Device to a Panel
To mount the device to a DIN rail, do the following:
1.
2.
2.3.2 Mounting the Device to a Panel
For panel installations, the RUGGEDCOM RX1512 can be equipped with panel/DIN rail
adapters pre-installed on each side of the chassis. The adapters allow the device to
be attached to a panel using screws.
8
Align the adapters with the DIN rails and slide the device into place.
Panel/DIN Rail Adapter
1
DIN Rail
2
Screw
3
Figure 2.1 DIN Rail Mounting
Install one of the supplied screws on either side of the device to secure the
adapters to the DIN rails.
3
2
1
Installation Manual, 04/2021, C79000-G8976-1057-20
1
2
RUGGEDCOM RX1512