TitanGPS TT-IoTSolar Quick Install Manual

STEP 1:
Determine Mounting Location
Device should be mounted with the solar panel facing up on a flat horizontal surface that
is perpendicular to the sun with a clear view of the sky
Device can be mounted sideways, but this can negatively a ect the charging rate of
the device
Secure with double-sided adhesive tape and/or screw directly to the asset
If using double-sided adhesive tape:
Surface must be clean, smooth and dry
Ambient temperature must be above 10°C/ 50°F
Apply at 80lb (350N) force to the asset for a minimum of thirty seconds to achieve full
bonding strength. Tape is generally 50% cured a er 20 minutes, 90% a er 24 hours
and 100% a er 72 hours.
Failure to adhere to these instructions could lead to the device becoming detached
from the asset in the field
If using screws:
Use existing mounting holes with included screws
DO NOT over-tighten screws as they will crack the base (DO NOT exceed 1.2 N.m (10
in.lb) torque)
These guidelines are meant to maximize
the performance of the unit.
TT-IoTSolar
STEP 2:
Testing the Device
IMPORTANT: Always be sure to test the device BEFORE sending the asset into the field
a) Ensure the asset is outside so the TT-IoTSolar has a clear view of the sky
b) Allow su icient time for the device to report at its pre-programmed interval
c) Login to the Titan GPS platform to confirm device reports at the programmed interval
at your location
Questions?
We're here to help!
1.855.287.4477
8AM - 5PM Monday to Friday MT
QUICK INSTALL GUIDE