Possible Malfunctions - Scholl CP 330 Instructions For Use Manual

GBA C 6001 12 E
7 P
OSSIBLE MALFUNCTIONS
Problem
No function
No display function
No cooling
No heating
Bad cooling
Display shows
"FIH" or "Fill"
Temperature varies for
more than 20° C
The problems listed above are for guidance and must be seen as examples. Should these or similar prob-
lems occur, immediately turn off the device and discontinue use. Contact a qualified specialist or the
manufacturer immediately.
Noise during operation (only for compact system)
To keep the selected temperature constant when cooling, from time to time, the hot or cold combiplate
switches the compressor of the cooling unit on. The sounds which occur are related to functionality. They
will reduce automatically as soon as the unit has reached operating temperature. The humming noise
comes from the compressor.
BA
Last revised 05-2021
Cause
• Power plug not plugged in
properly
• Fuse of the power supply has
tripped
• Controller not plugged in
properly
• Controller cable disconnected
• Controller cable not connected
correctly

Compressor turned off

Temperature controller faulty

Temperature above 40 °C

Power supply interrupted

Heating element is faulty

Temperature controller faulty
• Evaporator dirty
• Fan dirty
• Overheating on installation site
• Broken sensor
• Broken sensor
Page 21 of 26
Remedy
• Pull out the plug and insert it
correctly
• Check fuse, test unit on a differ-
ent elec. socket
• Note connection plan
• Check the connection
• Note connection plan

Check supply and exhaust air

Contact the seller

Allow device to cool down to
below 40 °C
• Check power supply
• Contact the seller
• Contact the seller
• Cleaning by service engineer
• Cleaning by service engineer
• Check supply and exhaust air
• Contact the seller
• Contact the seller
• Don't further use the device to
prevent subsequent damage
Mai 5, 2021
Rev. 12