Control Panel - Scholl CP 330 Instructions For Use Manual

GBA C 6001 12 E
5.3.1 C
ONTROL PANEL
The hot or cold combiplate can be set and operated via the touch control panel mounted on the front. The
five buttons are used for adjusting settings, switching (between heating or cooling mode), quick choice
between preset values, as well as parameterization. Only press the buttons using a finger or a Touchpen.
ON/OFF button
Button
Button
Selection button
Display hot mode
Display cool mode
Digital display
ATTENTION!
A change in the preset parameters should only be carried out by customer service.
When switching from heat to cooling mode, the compressor will only start once an actual temperature of
+40° C has been reached.
When turning the device off at a temperature over 40 °C, the ACTUAL temperature and OFF flash alter-
nately in the digital display.
BA
Last revised 05-2021
With this button the device is turned on or off.
When turning it on, the last selected mode starts.
These buttons are for adjusting the temperature.
By pressing the
ture will be shown in the display. To change the
temperature press
adjust the temperature accordingly.
The button is used to switch between the heating
or cooling mode. The respective preset setpoint is
effective for control.
The device is in heating mode.
The unit is in cooling mode.
Shows the actual and by pressing the
the target temperature.
Page 18 of 26
button, the adjusted tempera-
and either or , to
button
Mai 5, 2021
Rev. 12