Page 1
INSTALLATION MANUAL PUSH PULL WALL MOUNT MODEL SERIES VESA DISPLAY SIZE MAX LOAD LGC-5565 PUSH PULL 200x200 to 55” to 65” 110 lbs (50 kg) WALL MOUNT 600x400 www.logicav.in...
Checklist Right interface Connecting rod x 2 Right wall mount x 1 W-A: Concrete bracket x 1 Left wall mount x 1 Screw x 6 Left interface bracket x 1 M-A: M8 X 25 x 4 M-B: plastic x 4 M-C: M-D: M-E:...
2. Installation Choose below method for fixing wall mount. ATTENTION: Drilling the wall for the wall mount should be executed by a craftsperson only Exercise care to prevent any scar or damage to the wall. CAUTION : Wear safety glasses while operating power equipment. Failure to comply may result in eye injury 1.
Page 4
3. Drill the wall and insert the Fischer expansion plugs into the holes place the mount on the wall and insert concrete screw. (Refer W-A, W-B, W-C in the checklist) 4. Insert the connecting rod into the wall rail www.logicav.in...
Page 5
5. Screw the knob to the connecting rod (Refer knob M-E in the checklist) 6. Place the interface bracket on the TV/ display and insert the washer and screw (Refer the checklist for the suitable screw and washer) www.logicav.in...
Page 6
Angle adjustment details 7. Rotate the interface bracket both the knob anti clock wise and adjust for the required angle than rotate clock wise for tighten the knob 8. Rotate the screw using alien key for height adjustment of 25mm www.logicav.in...
Page 7
Height adjustment details 9. Rotate the screw using alien key for angle adjustment. www.logicav.in...
Page 8
10. Place the top side of the interface on the top connecting rod and than pull the lock as shown in image and place on the bottom connecting rod 11. After finishing the installation place the lock on the mount as shown in image. Final view after installing the mounted display on the wall www.logicav.in...