Table of Contents
Advertisement
Gas - Meritus
Switch ON/OFF
Turn Pilot Burner ON/OFF
•
1. Push and turn the Gas Valve full down anticlockwise to reach position ().
2. Burn the Pilot Open Burner with igniter gun wait between 15 seconds and then release.
3. If the Pilot flame extinguishes, repeat the above steps (1 and 2).
4. After lighting the pilot burner, turn the Gas Valve more until the position maximum flow
reached
5. Return the Gas Valve to position
6. Push and return the Gas Valve until OFF position (●)
Turn Oven Burner ON/OFF (Fig.20)
•
1. Open the oven door. Push and turn the Thermostat Control Knob fully down into position (),
while ignite the Pilot Burner by using Piezo Igniter.
2. Push the Thermostat Control Knob for about fifteen seconds.
3. Check the Pilot flame through the hole in base oven panel.
4. If the pilot flame extinguishes, repeat the above steps (1-4).
5. After ignite the pilot flame, turn the Thermostat Control Knob to position temperature degree
(100°-310°) to adjust heat
6. Below are the operating temperatures at different position of the Thermostat Control Knob:
100
C
240
o
135
C
275
o
170
C
310
o
205
C
o
7. Push and return the Thermostat Control Knob until OFF position (●)
ATTENTION!
When you want to start the appliance in the cold condition (like in the morning after along time for not
being used), you have to wait at least two minutes before turning the main burners on. Therefore,
thermocouple can warm up and provide the voltage needed for the valve work.
NAYATI
and only Pilot flame remain ON.
C
o
C
o
C
o
NOTE!
Only NGR that has oven burner.
34
GB – Gas Range Series
Fig. 20
FRM-PDE-03-04
20151125
Advertisement
Table of Contents
