NEC DLP Cinema NC1700L User Manual page 32

2. Installation and Connection
Using the supplied power cable stopper
To prevent the power cable from accidently removing from the AC IN of the projector, attach the supplied power cable stopper to
clamp the power cable.
CAUTION
• To prevent the power cable from coming loose, make sure that all the prongs of the power cable are fully inserted into the AC
IN terminal of the projector before using the power cable stopper to fix the power cable. A loose contact of the power cable
may cause a fire or electric shock.
• Do not bundle the power cable. Doing this could cause heat or a fire.
• Do not clamp the power cable with other cables. Doing so can generate noise, which can affect adversely the signal
NOTE
cable.
• Be careful not to insert the band inversely. Once the band is attached, it cannot be removed from the slot.
Attaching the power cable stopper
1
Insert the end of band of the power cable stopper into the slot next to the AC IN on the terminal
panel.
2
Use the power cable stopper to clamp the power cable.
Push the clamper to lock it.
clamper
32