Selecting The Chime; The Procedure For Connecting The Transmitter To Existing Bell System Or Existing Doorbell Button - Silvercrest 104412 Assembly, Operating And Safety Instructions

Selecting the chime

Note: The doorbell has 16 different chimes.
Press the melody selection button
sounds.
Press the melody selection button
next audible signal.
Repeat this process until you have selected your desired audible
signal. The last-selected audible signal is automatically stored.
The procedure for connecting the
transmitter to existing bell system or
existing doorbell button
Remove the holder
the transmitter and remove the rubber cover
Open the inner cover
Remove the plastic clip of cable exit hole
screw driver (see fig. G).
Insert the cable through cable holder
(see fig. H).
Connect cable to the terminals A and C (for connecting to exist-
ing doorbell) or the terminals B and C (for connecting to existing
door bell button) by using screw driver (see fig. H).
18 GB/IE
4
4
by pressing the lock
12
by cross head screw driver (see fig. F).
14
. The first audible signal
again to move on to the
from the back of
11
(see fig. C1).
15
with a flat head
18
and cable exit hole
19 18