Atag VA9111RT User Manual page 38

38
Malfunction
After the check, switch on the appliance. The
programme continues from the point of in-
terruption.
If the malfunction shows again, contact the
service centre.
If the display shows other fault codes, con-
tact the service centre.
The necessary data for the service centre is
on the rating plate.
The washing results and drying results are not satisfactory
Problem
The dishes are not clean.
Limescale particles on the
dishes.
There are streaks, milky stains,
or a bluish layer on glasses and
dishes.
Dry water drop stains on glasses
and dishes.
Fault code
The mains plug is not
connected in.
Blow out fuse in the
household fuse box.
The delay start is set.
We recommend that you write the data here:
Possible cause
The selected washing pro-
gramme was not applicable for
the type of load and soil.
The baskets were not loaded
correctly, water did not touch all
surfaces.
The spray arms could not turn
freely because of incorrect ar-
rangement of the load.
The filters are dirty or not as-
sembled and installed correctly.
The quantity of detergent was
not sufficient or missing.
The salt container is empty.
Incorrect water softener adjust-
ment
The salt container cap is not
closed correctly.
Rinse aid dosage is too high.
Rinse aid dosage is too low.
The detergent can be the cause. Use a different brand of deter-
Possible cause
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
Make sure that the washing pro-
gramme is applicable for the
type of load and soil.
Load the baskets correctly.
Make sure that an incorrect ar-
rangement of the load does not
cause a blockage of the spray
arms.
Make sure that the filters are
clean and correctly assembled
and installed.
Make sure that the quantity of
detergent is sufficient.
Fill the salt container with dish-
washer salt.
Adjust the water softener.
Make sure that the salt container
cap is closed correctly.
Decrease the rinse aid dosage.
Increase the rinse aid dosage.
gent.
Possible solution
Put in the mains plug.
Replace the fuse.
If you want to cancel
the delay start, refer to
'Select and start a
washing programme'.
....................
....................
....................
Possible solution