Atag VA9111RT User Manual page 23

• Do not remove the dishes from the appli-
ance until the washing programme is com-
pleted.
Care and cleaning
• Before you clean the appliance, deactivate
it and disconnect the mains plug from the
mains socket.
• Do not use flammable products or prod-
ucts that can cause corrosion.
• Do not use the appliance without the fil-
ters. Make sure that the installation of the
filters is correct. An incorrect installation
causes unsatisfactory washing results and
damage to the appliance.
• Do not use spray water or steam to clean
the appliance. Risk of electrical shock and
damage to the appliance.
Installation
• Make sure that the appliance is not dam-
aged. Do not install or connect a damaged
appliance, contact the supplier.
• Remove all packaging before you install
and use the appliance.
• Only a qualified person must do the elec-
trical installation, the plumbing and the in-
stallation of the appliance. This to prevent
the risks of structural damage or injury.
• Make sure that the mains plug is discon-
nected from the mains socket during in-
stallation.
• Do not drill into the sides of the appliance
to prevent damage to hydraulic compo-
nents and electrical components.
• Important! Obey the instructions in the
template supplied with the appliance:
– To install the appliance.
– To assemble the door panel.
– To connect to the water supply and
drain.
• Make sure that the appliance is installed
below and adjacent to safe structures.
Frost precautions
• Do not install the appliance where the tem-
perature is less than 0 °C.
• The manufacturer is not responsible for
frost damage.
Water connection
• Use new hoses to connect the appliance
to the water supply. Do not use used ho-
ses.
• Do not connect the appliance to new pipes
or pipes not used for a long time. Let the
water flow for some minutes, then connect
the inlet hose.
• Make sure not to squash or cause damage
to the water hoses when you install the
appliance.
• Make sure that the water couplings are
tight to prevent a water leakage.
• The first time you use the appliance, make
sure that the hoses do not have water
leaks.
• The water inlet hose has a safety valve and
a double sheath with an inner mains cable.
There is pressure in the water inlet hose
only when the water flows. If there is a leak
in the water inlet hose, the safety valve in-
terrupts the flow of water.
– Be careful when you connect the water
inlet hose:
– Do not put the water inlet hose or the
safety valve in water.
– If the water inlet hose or the safety
valve are damaged, immediately dis-
connect the mains plug from the
mains socket.
– Contact the service centre to replace
the water inlet hose with safety valve.
Warning! Dangerous voltage.
Electrical connection
• The appliance must be earthed.
• Make sure that the electrical information
on the rating plate agrees with the power
supply.
• Always use a correctly installed shock-
proof socket.
• Do not use multiple plugs and extension
cables. There is a risk of fire.
• Do not replace or change the mains cable.
Contact the service centre.
23