Installing And Cleaning The Cartridge Filter - Craftsman CMXEVCVVBVA1612 Instruction Manual

16 u.s. gallon wet/dry vac
Table of Contents

Advertisement

Available languages

Available languages

ENGLISH
particles. The cartridge filter should be used
for dry pick-up only. A dry cartridge filter is
necessary to pick up dust. If the cartridge filter
is wet, it will clog quickly and be very difficult
to clean. Handle the filter carefully when
removing it for cleaning and replacing it. Check
the filters for tears or small holes. A small hole
can let dust pass through and out of the filter.
Do not use a filter with holes or tears; replace
it immediately.
INSTALLING AND CLEANING THE
CARTRIDGE FILTER:
WARNING:
POWER CORD IS DISCONNECTED FROM THE
OUTLET.
23. Remove the power head and place in an
upside down position.
24. Install the cartridge filter
cage making sure the cage is completely
covered. Fig. 14.
Fig. 14
25. Place the filter retainer
the cartridge filter
and tighten down by turning the retainer
clockwise; do not over-tighten. Fig. 15 &
16.
8
VERIFY THAT THE
26
over the filter
27
on the top of
26
over the raised lip
Fig. 15
Fig. 16
26. To remove the cartridge filter, unlock and
remove the filter retainer
retainer handle counter-clockwise. Fig. 17
& 18.
Fig. 17
Fig. 18
27. With the removed power head in an upside
down position, carefully remove the
26
cartridge filter
Fig. 19.
27
by turning the
from the filter cage.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents