General Setup - Craftsman CMXEVCVVJC809 Instruction Manual

2. Lift the power head
8
tank .
3. Remove the contents from inside the
collection tank 8 ; make sure you have all
contents as listed on page 2.
ASSEMBLY
Caster System Assembly
4. Turn the collection tank upside down and
insert the four caster feet
on the collection tank and tighten with
12
supplied screws
feet 5 are mounted correctly. Do not over-
tighten screws. Fig. 1.
Fig. 1
Handle Assembly
11
5. Insert the handle
on the top of the power head
it with the screws
tighten screws 12 . Fig. 2.
Fig. 2
2
off the collection
5
into the slots
. Verify that the caster
into the slots located
2
and secure
12 provided. Do not over-
GENERAL SET UP
6. Your vacuum comes ready for dry vacuum
cleaning. If the cartridge filter is not
installed, refer to page 7 for installation
instructions.
7. For wet vacuum cleaning, remove the
cartridge filter, and install the supplied foam
wet filter. See page 8-9 for the foam wet
filter installation instructions.
8. Place the power head back on the collection
tank and secure into place using the latches.
9. Insert the larger end of the hose
vacuum port on the collection tank
lock into place. Fig. 3.
Fig. 3
10. Choose the desired accessory
and/or extension wands
the end of the hose
Fig. 4
11. Plug the power cord into the outlet.
Turn the motor on by flipping the on/off
10
switch to the 'I' ON position and begin
vacuuming. Fig. 5.
ENGLISH
13
into the
8 and
15 16
14
and insert onto
13 . Fig. 4.
5