Unpacking Your Wet/Dry Vacuum; General Assembly - Craftsman 125.38909 Operator's Manual

Assembly (continued)
A Phillps head screw driver is required.
,_, WARNING: Do not plug in power
cord to power outlet, make sure
plug is disconnected before
assembling the wet/dry vac.
UNPACKING YOUR WET/DRY
VACUUM & GENERAL ASSEMBLY
1. Ensure that the power cord is
disconnected from the power outlet.
(Fig. 1)
2. Undo the latches. (Fig. 2)
3. Lift the top section off the tank.
(Fig. 3)
4. Remove the contents from inside the
collection tank, make sure you have
all contents as listed on carton
content list on page 5. (Fig. 4)
5. Turn the tank upside down, and
insert the casters on to the four feet
of the tank. Ensure that they are
mounted correctly. Do not over
tighten. (Fig. 5)
6. insert the handle into the slots on
the power head and pressure into
place.(Fig. 6)
7. For dry vacuum cleaning, install the
supplied cartridge filter. (Fig.7)
8. For wet vacuum cleaning, install the
supplied foam filter. (Fig. 8)
9. Replace the top section on the tank.
(Fig. 9)
10. Align the top section with the
clasps and snap into place by
applying pressure until clasps click.
(Fig. 9)
11. insert the large end of the hose
into the front inlet of the tank and
turn to lock,Fit the required
accessory on to the suction tube.
(Fig.10 & Fig.11)
12. After vac use, store hose,
accessories and cord as illustrated
on page 12.