Unpacking Your Wet/Dry Vacuum; General Assembly - Craftsman 125.12004 Operator's Manual

Assembly (continued)
A Phillps head screw driver is required.
,_, WARNING: Do not plug in power
cord to power outlet, make sure
plug is disconnected before
assembling the wet/dry vac.
UNPACKING YOUR WET/DRY
VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is
disconnected from the outlet.
(Fig. 1)
2. Undo the latches. (Fig. 2)
3. Lift the power head off the collection
tank and place on a flat clean
surface. (Fig. 3)
4. Remove the contents from inside the
collection tank, make sure you have
all contents as listed on carton
content list on page 5. (Fig. 4)
5. With the power head removed, turn
the collection tank upside down.
insert the four caster assemblies
into each socket. Apply pressure
until caster assemblies fully seated.
(Fig. 5) Secure them with the screws
provided. Do not over tighten the
screws.
6. Position the hose storage rack
as illustrated, insert one side of the
rack into the channel making sure
it is secured in place. Squeeze in
the other end and insert it into the
corresponding channel making sure
it is secured. (Fig. 6a = Fig. 6d)
7. Place the power head back on the
collection tank, and secure into
place using the 2 side latches.
(Fig. 7 & Fig. 8)
8. insert the locking end of the hose
into the port on the collection tank
and turn to lock in to place. (Fig. 9)
9. Choose the desired accessory and
insert onto the end of the hose
(Fig. 10)
10. After vac use, store hose,
accessories and cord as illustrated
on page 12.