Table of Contents
Advertisement
Front cover
HART communication
sockets
VEGATRENN 151 •
6
Setup
6.1
Bediensystem
1
1
2
2
Fig. 1: Anzeige- und Bedienelemente
1
HART-Kommunikationsbuchsen
2
Aufklappbare Frontblende
6.2
Adjustment elements
The adjustment elements are located under a hinged front cover. To
open it, use a small screwdriver in conjunction with the slot on the
upper side of the front cover. To close it, push the cover at bottom and
top firmly onto the front cover until you hear the two retaining clips
snap in.
No adjustment or configuration of VEGATRENN 151 is necessary.
Via the HART communication sockets, parameter adjustment of the
connected HART sensors can be carried out without interrupting the
measuring circuit. The resistor (230 Ω) required for this purpose is
already integrated in VEGATRENN 151 (only in case of connection of
terminals 10/12). The adjustment of the connected sensor is carried
6 Setup
13
Advertisement
Table of Contents
