Going To The Function Select Mode; Setting The Unit Number; Select A Mode; Selecting The Setting Number - Mitsubishi Electric SUZ-KA24NAHZ Service Manual

15-5-3. PAR-SL100A-E
Fig. 15-1
Fig. 15-2
Fig. 15-3
Fig. 15-4
OCH754A

1. Going to the function select mode

Press the
(Start this operation from the status of remote controller display turned off.)
[CHECK] is lit and "00" blinks. (Fig. 15-1)
Press the button to set the "50".
Direct the wireless remote controller toward the receiver of the indoor unit and
press the

2. Setting the unit number

Press the button to set unit number A. (Fig. 15-2)
Direct the wireless remote controller toward the receiver of the indoor unit and
press the
A

3. Select a mode

Press the button to set Mode number B. (Fig. 15-3)
Direct the wireless remote controller toward the receiver of the indoor unit and
press the
Current setting number:
B

4. Selecting the setting number

Use the button to change the Setting number C. (Fig. 15-4)
Direct the wireless remote controller toward the receiver of the indoor unit and
press the
5. To select multiple functions continuously
Repeat select 3 and 4 to change multiple function settings continuously.
6. Complete function selection
Direct the wireless remote controller toward the sensor of the indoor unit and
C
press the
Note: Be sure to write down the settings for all functions if any of the initial
settings has been changed after the completion of installation work.
115
button between of 5 seconds.
button.
button.
button.
1=1 beep (1 second)
2=2 beep (1 second each)
3=3 beep (1 second each)
button.
button.