Operating Instructions - Wickes CDI218BW Manual

OPERATING INSTRUCTIONS

NOTE: Before using the tool, read the instruction book carefully.
Intended Use
The machine is intended for driving in and loosening screws as well as for drilling in wood, metal and plastic.
BEFORE PUTTING INTO OPERATION
A) CHARGING THE BATTERY
a) Do not use any charger other than that specifically provided for use with the equipment.
b) If the battery pack is very hot you must remove your battery pack from the charger and allow time for the battery
to cool down before recharging.
c) The battery in your new tool is not charged when it leaves the factory. It must be fully charged before using for the
first time.
d) The battery must be fully charged before storage. If the tool is not used for long periods, recharge the battery at
least every 3-6 months.
B) TO REMOVE THE BATTERY PACK (See Fig. A1)
Depress the battery pack release button (8) firmly first
and then slide the battery pack (7) out from your tool.
C) TO INSTALL THE BATTERY PACK (See Fig. A2)
Slide the fully charged battery pack (7) onto the tool with
sufficient force until it clicks into position.
1
Fig. A1
Fig. A2
11
2