Operating Instructions - Wickes CDT212W.4 Original Instruction

OPERATING INSTRUCTIONS

NOTE: Before using the tool, read the instruction book carefully.
Intended Use
The machine is intended for driving in and loosening screws as well as for drilling in wood, metal and plastic.
BEFORE PUTTING INTO OPERATION
A) CHARGING THE BATTERY
The battery supplied is partially charged. To ensure full capacity of the battery, completely charge the battery in the
battery charger before using your power tool for the first time.
The battery charger supplied is matched to the Li-ion battery installed in the machine. Do not use another battery charger.
The Li-ion battery is protected against deep discharging. When the battery is empty, the machine is switched off by
means of a protective circuit: The chuck no longer rotates.
NOTE: If the battery pack is very hot you must remove your battery pack from the charger and allow your battery pack to
cool first to ambient temperature and then recharging can be started.
To prevent damage to the battery pack, when charge runs out, charge the battery to reach full or no less than
half charge before storage.
If the tool will not be used for long periods of time, charge the battery every 3-6 months.
B) TO REMOVE THE BATTERY PACK (See Fig. A1)
Depress the Battery Pack Release Button (7) firmly first
and then slide the Battery Pack (6) out from your tool.
C) TO INSTALL THE BATTERY PACK (See Fig. A2)
Slide the fully charged Battery Pack (6) onto the tool with
sufficient force until it clicks into position.
Fig. A1
Fig. A2
11