Wickes CDI218BW Manual page 14

6. TORQUE ADJUSTMENT (See Fig. F)
(Screw driving force of your drill)
The torque is adjusted by rotating the torque adjustment
ring (2). The torque is greater when the torque adjustment
ring is set on a higher setting. The torque is less when
the torque adjustment ring is set on a lower setting.
Make the setting as follows:
1 - 4 for driving small screws
5 - 9 for driving screws into soft material
10 - 14 for driving screws into soft and hard material
15 - 20 for driving screws into hard wood
21 -22 for driving larger screws
for heavy drilling
for drilling in masonry and concrete
7. USING THE WORK LIGHT
The work light (9) will illuminate whenever the On/Off switch (10) is pressed. LED lighting increases visibility, great for
dark or enclosed areas.
8. BELT CLIP
Screw the belt clip (6) on the tool with the screw provided in the plastic bag. The belt clip (6) can be hooked on your belt
or pocket, etc.
9. BATTERY CAPACITY INDICATOR (See Fig. G)
Your tool is equipped with battery capacity indicator.
Press the on/off switch halfway or fully, the battery
capacity indicator will light up to show the amount of
charge left in the battery.
Fuel Gauge
Red on
Red on +Yellow on
Red on +Yellow on + Green on
Green on
Fig. F
Capacity
0-33%
33%-66%
66%-100%
Fully Charged
Fig. G
14