Maintenance; Environmental Protection - Wickes CDI218BW Manual

2. THE DRILL STOPS BEFORE THE SCREW IS COMPLETELY TIGHTENED. WHY?
Verify the torque position of the torque adjusting ring (2), you can find the torque adjusting ring between the chuck and
the drill body. Position 1 is the lowest torque (screw driving force) and position 22 is the highest torque (screw driving
force). Position is for drill operation. Position
higher position to reach the best result.
3. REASONS FOR DIFFERENT BATTERY PACK WORKING TIMES
Charging time problems, as above, and having not used a battery pack for a prolonged time will reduce the battery pack
working time. This can be corrected after several charge and discharge operations by charging & working with your drill.
Heavy working conditions such as large screws into hard wood will use up the battery pack energy faster than lighter
working conditions. Do not re-charge your battery pack below 0

MAINTENANCE

Remove the battery pack from the tool before carrying out any adjustment, servicing or maintenance.
Your tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool. Never use water or chemical cleaners to clean your power tool.
Wipe clean with a dry cloth. Always store your power tool in a dry place. Keep the motor ventilation slots clean. Keep all
working controls free of dust. Occasionally you may see sparks through the ventilation slots. This is normal and will not
damage your power tool.
For Battery tools
The ambient temperature range for the use and storage of tool and battery is 0°C-45°C.
The recommended ambient temperature range for the charging system during charging is 0°C-40°C.

ENVIRONMENTAL PROTECTION

Waste electrical products must not be disposed of with household waste. Please recycle where facilities exist.
Check with your local authorities or retailer for recycling advice.
is for hammer drill operation. Regulate the torque adjusting ring to a
C and above 40
o
16
C as this will affect performance.
o