Table of Contents
Advertisement
en Cleaning and servicing
To switch the lighting on, touch
1.
15.5 Overview of the hood control settings
You can change the behaviour of your extractor hood in the basic settings of your hob, depending on switch-on/off
of the hob or individual cooking zones.
Setting
Selection
– Not connected/disconnect
– Start connection process
– Connected to WLAN home network (Wi-Fi)
– Connected to extractor hood
– Switched off. The extractor hood will need to
be switched on manually, if required.
– Switched on in automatic mode
mode the extractor hood switches itself on when
one of the cooking zones is switched on.
– Switched on in manual mode. The extractor
hood is switched on at a specified setting when a
cooking zone is switched on.
– Fan switches off when the hob is switched off.
– Switched on in automatic mode
– Switched on with standard fan run-on
– No change to settings
– Switched off
– Switched on
The light switches itself on when the hob is
switched on.
– Switched off
– The light switches itself off when the hob is
switched off.
1
Factory setting (may vary according to model)
16
Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
16.1 Cleaning products
You can obtain suitable cleaning products and glass
scrapers from customer service, the online shop or a
retailer.
ATTENTION!
Unsuitable cleaning products may damage the sur-
faces of the appliance.
Never use unsuitable cleaning products.
▶
Unsuitable cleaning products
¡ Undiluted detergent
¡ Detergent intended for dishwashers
¡ Abrasive cleaners
¡ Aggressive cleaning products such as oven spray
or stain remover
¡ Abrasive sponges
¡ High-pressure or steam jet cleaners
18
.
1
. In automatic
1
1
1
To switch the lighting off, touch
2.
Description
Connection hob - extractor hood
Automatic fan start-up
The display shows this setting only when the appli-
ance has been connected to the extractor hood.
Fan run-on
Setting whether / how fan is to run on after switch-
ing off the hob.
The display shows this setting only when the appli-
ance has been connected to the extractor hood.
Light switched on automatically
The display shows this setting only when the appli-
ance has been connected to the extractor hood.
Light switched off automatically
The display shows this setting only when the appli-
ance has been connected to the extractor hood.
16.2 Cleaning the glass ceramic
Clean the hob after every use to stop cooking residues
from getting burnt on.
Note: "Note the information on unsuitable cleaning
products." → Page 18
Requirement: The hob has cooled down.
Remove heavy dirt using a glass scraper.
1.
Clean the hob with a cleaning product for glass
2.
ceramic.
Follow the cleaning instructions on the product
packaging.
Tip: You can achieve good cleaning results if you
use a special sponge for glass ceramic.
16.3 Cleaning the hob surround
Clean the hob frame after use if dirty or stained.
Notes
¡ "Note the information on unsuitable cleaning
products." → Page 18
¡ Do not use the glass scraper.
Clean the hob frame with hot soapy water and a soft
1.
cloth.
Wash new sponge cloths thoroughly before use.
again.
Advertisement
Table of Contents
