PROBLEMS
Oven door sagging on one side
Door does not close completely at top
Door glass breaks.
Damaged oven door gasket.
Oven racks fit too tight.
Oven smokes/odor first few times of
usage
Excessive smoking during a Self clean
cycle
Convection fan make a noise
Failures Codes
Oven temperature too hot or too cold
TROUBLE SHOOTING
POSSIBLE CAUSES
• Hinge loose or out of position to oven liner
• Broken or misadjusted door spring
• Door fits too tight at bottom.
• Oven racks covered with foil.
• Glass installed backward.
• Improper Self clean
• Racks were cleaned in self clean cycle
• Tolerance buildup in oven liner.
• This is normal
• Excessive soil
• A convection fan may automatically turn on
and off.
Low level noise is normal
• Loose nut of convection fan
• Deformed convection fan
• Electronically controlled
• Oven sensor needs to be adjusted
• Adjust hinges or replace hinges
• Adjust or replace hinges
• Adjust hinges outward.
• Do not cover racks with foil.
• Install tempered glass toward the heat.
• Do not use harsh abrasives or scouring pads. See Owner's
manual intructions
• Apply a small amount of vegetable oil to a paper towel and wipe
the edges of the oven racks with the paper towel. Do not spray
with pam or other lubricant sprays.
• Notify customer Assurance department.
• Minor smoking or odor is normal for the first few tikes of oven
usage
• Ventilate area well and perform self clean cycle
• Press the CLEAR/OFF pad. Open the windows to rid the room of
smoke. Wait until the Self Clean cycle is cancelled Wife up the
excess soil and reset the clean
• Low level noise is normal
• Re-fasten the nut
• Replace the convection fan.
• Refer to "Failure codes" parts (page 7-1)
• See "the adjusting your oven temperature" in owners manual
-11-3-
SOLUTIONS