Factory Servicing; User Interface Menu Tree - Demtech Pro-Tester Double-Pull Operator's Manual

6 Factory Servicing

In the event your Pro-Tester
returned to the factory. Refer to the following step for preparing the Pro-Tester
Carefully pack the Pro-Tester
the welder for return to DEMTECH Services, Inc.'s factory for service. Unless previous
arrangements are made, shipping charges and insurance are the responsibility of the
customer. Ship the packaged Pro-Tester

7 User Interface Menu Tree

Refer to Page 15 for the Pro-Tester
if you are trying to find a particular function or setting you wish to access. Use the drawing
to locate the particular item you want to access. Once located, follow the tree back to the
top level. Next, utilizing the user interface on the Pro-Tester
the menu structure using the drawing as a guide to access the particular screen you want.
To enter the Menu Mode make sure the Pro-Tester
(Refer to Page 15). Simultaneously press and hold the YES and No buttons on the
Control Panel for several seconds.
Page 13
TM should require factory service, the entire welder needs to be
in the reusable portable shipping/storage case provided with
TM
TM to DEMTECH Services, Inc. at:
DemTech Services, Inc
Ship to address: 6414 Capitol Avenue
Diamond Springs, CA 95619
U.S.A.
TM Menu Tree drawing. This drawing can be very helpful
Rev. C, October 2020
, proceed back down through
TM
TM is on and at the main operating screen
Pro-Tester Operator's Manual
TM for return.