Factory Servicing; User Interface Menu Tree - Demtech Pro-Tester Hi-Pull Operator's Manual

6 Factory Servicing

In the event your Pro-Tester Hi-Pull
to be returned to the factory. Refer to the following step for preparing the Pro-Tester Hi-
Pull for return.
TM
Carefully pack the Pro-Tester Hi-Pull
provided with the welder for return to DEMTECH Services, Inc.'s factory for service.
Unless previous arrangements are made, shipping charges and insurance are the
responsibility of the customer. Ship the packaged Pro-Tester Hi-Pull
Services, Inc. at:

7 User Interface Menu Tree

Refer to Page 15 for the Pro-Tester Hi-Pull
helpful if you are trying to find a particular function or setting you wish to access. Use the
drawing to locate the particular item you want to access. Once located, follow the tree
back to the top level. Next, utilizing the user interface on the Pro-Tester
down through the menu structure using the drawing as a guide to access the particular
screen you want. To enter the Menu Mode make sure the Pro-Tester
operating screen (Refer to Page 15). Simultaneously press and hold the YES and No
buttons on the Control Panel for several seconds.
Page 13
should require factory service, the entire welder needs
TM
in the reusable portable shipping/storage case
TM
DemTech Services, Inc
Ship to address: 6414 Capitol Avenue
Diamond Springs, CA 95619
U.S.A.
Menu Tree drawing. This drawing can be very
TM
Rev. A, October 2020
to DEMTECH
TM
, proceed back
TM
is on and at the main
TM
Pro-Tester Hi-Pull Operator's Manual