Dell 6350 Rack Installation page 30

1-16 Dell PowerEdge 6x50 Systems Rack Installation Guide
pull pin
offset
hinge
rail-mounting
plate

     +  $   *
%   & 
The following subsections describe procedures for replacing the rack doors on the
42-U rack and the 24-U rack.

 
     

1. Lift the front door into position and align the hinges with the holes in the rack as
shown in Figure 1-3.
2. Slide the hinges into the holes in the rack until the hinge release levers lock the
hinges into position.
3. Close the door latch by rotating the handle counterclockwise until it stops, push
in the handle until it locks in position, and then slide the button cover down over
the push button (see Figure 1-2).
4. Repeat steps 1 through 3 to install the back door, but turn the handle clockwise.
latch pin