Dell 6350 Rack Installation page 21

support.dell.com
hinge insert

      
If you want to reverse the door so that the handle is on the other side, perform the fol-
lowing steps:
1. With the door open, lift out and fully retract all hinge pins.
2. Remove the hinges and door brackets from the door frame.
3. Replace the hinges and door brackets on the opposite side and switch the posi-
tion of the handle.
4. Replace the rack door (see the section, "Replacing the Rack Doors," found later
in this guide).
'    !    
NOTE: If the slide assemblies were preinstalled by Dell, you can skip to the section,
"Installing the System in the Rack," found later in this guide.
Use the 4-U rack template to determine where you want to install the slide assem-
blies. The rack template is the same height as the computer chassis.
You must allow 4 U (7 inches) of vertical space for each PowerEdge 6x50 system you
install in the rack.
Dell PowerEdge 6x50 Systems Rack Installation Guide
hinge pin
hinge
1-7